jojoba má ALP. Může to být více věcí a bez firmwaru a statistiky neporadíme... Každopádně oslnění skončilo verzi RX 20.23. Není dáno, že se nemůže stát když ALP chytne přísvit a do toho zasvítí volvo, infinity, mazda, citigo atd..., ze to nehodí nějakou jinou hlášku. S ím se musí počítat, ale pokud je to jen na jednom místě jedná se o FP a neřešil bych to. Pokud jojoba chce může nám ten FP (falešný poplach) nahrát a pošleme ho výrobci. Zde je postup na nahrání:
Kód:
II. RECORDING MODE /enter 4x4x4 inside Service code Menu/
1. Make sure that an empty USB flash drive is inserted in to the ALP USB socket.
2. Press long Menu(next) button. LED will turn yellow.
3. In Yellow menu press Menu(next) button 7 times then press Enter. System enters
Service Codes menu (LED will turn white).
4. Now press Menu(next) button 4 times then press Enter.
Wait for sound sequence to finish. LED is white.
5. Press Menu(next) button 4 times then press Enter.
Wait for sound sequence to finish. LED is white.
6. Press Menu(next) button 4 times then press Enter.
Green signalling occurs showing that RECORDER.INI file has been saved to flash drive.
Restart ALP to enter Recording Mode.
Drive (or carry) the system near the laser source of interest. When signal is detected by the
Sensor(s) the LED will change to Red and short Beep will sound from the speaker. If signal is
captured correctly LED will turn Blue accompanied by a long Beep from the speaker. A
recorded file is created on the USB flash drive.
Unplug the USB drive and restart your ALP when you wish to exit recording mode.